Skull Book for dice or candy - Snap close - no magnets needed Free 3D print model

A book that you can use to store your dice, markers, candy, etc. Blank cover without the skull included. Can store approximately six sets of polyhedral dice.See print settings below!

Dimensions

Height: 175mm / 7"

Width: 125mm / 5"

Thickness: 37mm / 1.5"

Internal storage height: 30mm / 1.2"

I can adjust the size on request.

Best regards,Jonas

Cover:No infill needed

0.2mm layer height

2 walls

10% infill

To get a leathery look on the cover:

Enable Fuzzy skin

Fuzzy skin Point Distance 0.4mm

Fuzzy skin Thickness 0.1mm (max)

(Fuzzy settings are the same in most slicers but results may vary with printer model and outer wall print speed. Slower is better)

Pages:No infill needed

0.24mm layer height

3 Walls

10% infill