These are support brackets lasercut in 2mm thick aluminium that will prevent the buildplatform from sagging and vibrating which cause quality issues on prints.
They snap on, just replace the original screws on the side of the plastic arms with longer screws. I could only find M3x30 which are a little too long so that´s why i have included a spacer.
Instructions:
3d print the fill blocks, remove the 10 screws from the sides of the arms. Snap on the support brackets, secure it with the longer screws. And your done!
This project is licensed under the Creative Commons - Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0): http://creativecommons.org/licenses/by-sa/3.0/deed.en_US