V2 SCI FI BUGS 3D print model

Hello,

Here is my latest model V2 Sci Fi Bug (one of more to come). I thought id try a mecha sci fi bug design and this is what I made over the last week. Built in zbrush with no concept as usual - original designs. I initially made the legs too thin so had to rebuild with sturdy thicker set design which actually made it look better imo. I made lots of sunken panel designs around the model and set planes at angles to look aerodynamic and also catch the light from different angles. The images are mostly renders and I have added 3 photos of the raw print. Raw being snipped off suppports but have yet to trim off some support tips. You can only just see them in the photos. I printed this on my elegoo mars 3 with water washable resin with default settings. Auto supports and some extras I added where needed. I tilted the nose end up about 15-20 degrees. Took about 2.5 hours on default. Hope you like it and thanks to all who buy my models. Looks great in chrome too! If you need any help just send a message and I will reply promptly.

The size is 103.27mm X 62.82mm Y 120mm Z

(Please note * The photos of the print show the size flat on the build plate which was printed at the reduced size AT 75%) 77.45mm X 47.12mm Y 90.00mm Z

Thanks Calum