This model was designed by me in Solidworks, faithfully to the original, to scale. The surface texturing was then processed in Blender. This figure was printed and tested using PLA material FDM material printed the Bamboo Carbon X1 machine. I do not recommend exceeding 80% of the minimum size reduction. A 100% infill rate is recommended for the torch flames, carriage rail, and hinge covers. Other parts can be printed between 15% and 100%. A 15% fill rate was set for the sample print. It is also suitable for resin printing. It is recommended that you place the parts on the table, paying attention to the joints. All parts were printed vertically during the sample print.