A cutie Brown Wolverine - one of my favorite costumes of him.

This little guy is part of a serie os cute characters that I love! Some of them are from the family X.

The model does well with FDM printers, just look the images!

I made one using my Ender 3. You will need supports almost everywhere.

I hope you like it!

Also check out these cuties:

X-23: https://www.cgtrader.com/3d-print-models/miniatures/figurines/simple-x-23

Sabretooth: https://www.cgtrader.com/3d-print-models/miniatures/figurines/simple-sabretooth

TIP FOR THE CLAWS:

Print the claws together with any model that is taller than them and place the three models (the two claws + the tallest model) apart from each other on the printing table. There must be time to dry each layer before the next one is built), so use low speeds (I used 30mm/s and 0,1 layer).