This design is cheaper on cults at only $0.70, to find it go to cults 3d and type in kelpzo in the designs search bar.

I created this keyring based of Prime Hydration drink in tinkercad, it is roughly 6.75cm in height (standing up).The ring is strong and should not break easily, it takes about an hour and 20 minutes to print with the ender 3 s1.I coloured in the prime logo with pens, the model is all printed in one (the logo and bottle are not 2 separate parts they are one).

The supports in the letter R can be a little hard to remove

If you like Prime you can also have it on your keychain with this model! Prime was created by KSI and Logan Paul in 2022, You can print this in any colour you want to represent any of the flavours you want.

The mini filament keychain you see in image is is not my creation: https://www.thingiverse.com/thing:2300389

settings:

• Resolution: 0.2mm
• Supports: yes
• Infill: 10%
• Print Speed: 50mm/s
• I used a skirt when printing this.
• it is roughly 6.75cm in height (standing up).
• It should take roughly 1hr and 20m.