Evil Queen Brooch from Snow White

Printable Brooch for cosplay from the 1937 Disney Snow White film.

The brooch is designed to be printed on a resin printer. It is suggested to print the stone in transparent resin colored red.

For optimal printing results, it is recommended to use the “Hollow” & “Dig Hole” functions (Chitubox or PrusaSlicer) to create one or more holes to allow the resin to drain.

If you decide to print the brooch on a filament printer, the ornament surrounding the brooch may not have a good appearance.

The back of the brooch is flat. You can attach a ribbon, a safety pin, or a strip of Velcro, depending on how you want to attach the brooch to the costume.

The recommended size for the brooch is 2.76 inches / 7 cm diameter.

The size of the Brooch can be modified with any 3D design software or with any 3D printing software.