This is replacement of IF552 - Battery Tray for Kyosho MP10e, MP10e TKI, MP10e TKI2, MT10e.

For easier print I divided it into four parts - battery tray, 4 foots, 2 long supports and 1 short support. You need to glue supports to battery tray (using CA glue). You can also glue foots, or screw it using M3x6 FHCS screws. Also there are 2 versions of clamps (standard and +2mm for higher batteries) and 2 versions of battery filler for using with short lipos. You also need M3x12 screw for clamp and 2 valcro straps.

Print it with any filament you like: PETG, ABS, ASA, PACF. PLA can be to soft when lipos get hot! Use layer hieght 0.2 and 100% infill to make it rigid. Some support needed under straps mount.