Fully 3d Printable RC Aircraft - Piper Cub 3D print model

This is my 2nd model in my 3d printable RC airplane lineup. The total print weight using regular PLA is 430 grams, and the total print time is just below 60 hours. This aircraft has less parts than the 1st one, making the assembly process easier. The front cap comes off and attatches with adhesive once the electroncis are in the aircraft and is properly positioned to achieve balance. I used command strips to attatch the electronics unit to the aircraft. This aircraft uses carbon rods to connect the pieces together. Please use the attatched Carbon rod cut guide for proper dimensions. The rear landing gear was made from a bent 2mm dia stainless rod, and the control rods are made from 1mm dia stainless rods. All pieces are attatched with super glue. Hope you enjoy!