DAFT PUNK GUY HELMET WITH GLOVES ARDUINO 3D print model

COMPLETE STL files set for the helmet shown in the photos, and described on the Instructables page (link below) to 3D print your own parts, assemble it, and wire up a THREE arduino controller box for the LED lights. You will need to have access to a vacuum former to pull the visor as a 3D print version will be not usable to see out of. Review the Instructables page before purchasing as this is a very very difficult project to make, especially the wiring and programming. I can provide SOME assistance along the way but cannot debug your arduino programs. Comes with reference photos, wiring diagram, and two versions to print the helmet. One piece version requires a large format 300 x 300 mm table min. The glued up version has not been tested. Review ALL the files completely to get a good ideal how this goes together before printing. SEE INSTRUCTABLES LINK BEFORE PURCHASING (BELOW). Suggest printing the first 1 inch of the helmet to make a ring then trial it for proper sizing at this at 100% BARELY fits a 7-1/4" hat size. Email for specific questions before purches. No refunds as it is all there, it is up to your resources to make this work!NOTE: Photo seems to show you can see the individual LEDS, this is not as in real world but the camera sensitivity to the light. YOU CAN print a diffuser lens (included) but I dont think it is needed if you dye the visor dark enough.

Go Here for a video of the arduino routine and UV meter sound sensitivity www. youtube. com/watch?v=hrwQRS60yA4Go here for a walk through www. youtube. com/watch?v=9BYpmE7q71M

REVIEW THIS FIRST: https://www.instructables.com/Daft-Punk-LIVES-ON-My-Guy-Manuel-Helmet/