Nebuliser for delivering aerosolised drugs and natural therapies to the airways of the horse. Made on 3d scan of a horse - fits well. Allows the use of cheap and readily available human inhalers. They are usually weaker than the horse ones - so you can plug in two at once.

Comes with 4 3D models:1) main mask2) screw-in valve on the bottom3) Screw-in 6 cm front adapter - if You have some horse nebulizer already - the hole is a bit bigger - it is on purpose not to spoil the original equipment - use tape inside the hole to seal4) adapter for inhalers / nebulizers for children - with 1,5cm and 2cm holes5) adapter for inhalers / nebulizers for children - with out holes so You can make Your own that fits Your inhalers

Use:

• Pipe Insulation - Foam Pipe Lagging for isolation at the horse's face.
• Low-Level Toilet Cistern Gasket for valve on the bottom.

Both parts available at any DIY store / construction market.

It fits well on Pruisa i3 MK3 3d printer. Print main mask on 0.3 layer height, other parts on 0,2. Supports are needed.

If you need me to match / edit / correct any part for You - just let me know.

PRINT IN PET-G SO YOU CAN USE ALCOHOL FOR DISINFECTIONUSE ONLY UNDER DIRECTION OF A LICENSED VETERINARIANALWAYS WASH , DRY AND DISINFECT AFTER USE WITH ALCOHOLCHANGE OFTEN FOAM PIPE