This is a display stand for the Halloween Ends Trick or Treat Studios mask. It has an optional slot that fits the Halloween Ends knife model on my page and looks great when painted.

This model has 3 files:

Base: The main stand and sign.

Pole: The 50mm diameter pole that is either printable, or you could optionally use wood. (comes split into 2 parts that slot together).

Dome: The rounded top for the pole, and what the mask sits on.

Strength is important here, so these are my suggestions:

10 - 15 % infill

3 - 4 wall loops

All materials should work fine with this (excluding TPU). The model seen here was printed with PLA+. Support is only required for the dome but for all of the files you may want to consider a brim for strong bed adhesion.

Hope you enjoy! :)