Modeling scale: H0 (1:87)This is a set of railway traction poles. Each pole is printed from two parts, which must be glued together, then painted and mounted in the base. The base should be printed from marble filament. The base can be shortened (broken) and permanently attached to the model layout. These models are designed for printing in FDM technology with a 0.1 mm layerNote: I fully realize that the hanger elements are too thick, but this technology (FDM) does not allow printing strong elements that are smaller. The assumption was that commercially available catenary wires could be stably mounted on these poles (you must also be aware that commercially available catenary wires are also significantly oversized).