An Elven dagger design. An easy-to-make and process model for most 3D printers that comes in three parts; the blade is split in two and the grip is one whole unit. As shown in the pictures, the blade has a tang, and it slides right into the grip. All it takes is a little bit of epoxy to keep it there. Good for LARP, cosplay, etc. 13.3 inch blade from tang to blade tip, with an approximate 6.2 inch grip.

NOTES:

• The blade parts have two channels that will take a 0.1875 in. wooden dowel to keep it stable. Any sort of fast-acting super glue should keep the parts together.
• Through trial and error, the blade and the grip CANNOT be printed the same size. The grip should be printed at the bare minimum 8% bigger than the blade to allow it to slide in without having to force it in. Printing it smaller may cause it to break.

PRINT DETAILS:Infill: 20-30%
supports: Yes
Material: PLA
Device used: Creality Ender 3 V2 Neo