This is a 3D Model - The photos are not representations of a physical product that can be shipped. You are purchasing digital files only!

Cal Kestis/Jaro Tapal Lightsaber is a set of themed lightsaber parts obtainable in Jedi: Fallen Order video game. This is my take on the hilt design, made printable and customizable with my Lightsaber Assembly kit. This is what I imagined the 'repaired' version of his lightsaber could be, so that the parts are more easily interchangeable with my other saber parts. This is not a 1:1 replica of the game model, which appears damaged near the pommel area. This hilt is 454 mm (17.8 in) long when assembled as a single bladed hilt, and 643 mm (25.3 in) long when assembled as a dual bladed lightsaber. The diameter of the grip is about 1.75 in (45 mm).

This lightsaber kit is compatible with all my saber designs, and parts can be mixed and matched to make your own cutom saber!

This kit comes with a solid prop (uncut) lightsaber, as well as broken up into sections. Each section is named the same way for all my lightsaber designs.

• Shroud
• Emitter
• Switch
• Sleeve
• Pommel

This hilt will accept a 1" diameter Blade. The interior has a diameter of 29mm for electronics installation. The emitter has a 8mm hole leading to the blade end, enough for wiring to pass through. If you need modification for a specific kit, shoot me a message!

ASSEMBLY: The Lightsaber Assembly kit contains models for putting your hilt together. It comes with press fit parts, as well as threaded parts for easy customization. There are two sizes of adapters - 32 mm and 24 mm. The kit also includes a press fit 32 mm to 24 mm adapter so you can mix and match parts. It is recommended you print adapters at a high infill % for strength. This model uses the following adapters for each part:

• Emitter to Switch: 24 mm
• Switch to Sleeve: 32 mm
• Sleeve to Pommel: 32 to 24 mm adapter

PRINTER SETTINGS: No scaling is needed; this model was made to be a life size prop. Measurements for the hilt are in the photos. For higher quality, we reccommend a layer height of .1mm an any FDM printer. We recommend orienting the hilt sections vertically on your printer, and use supports where necessary.

Color preview included to show potential finished product. Does not represent an actual print.

I am happy to customize models to meet your needs. Just shoot me a message!

Model was created by Ben Watkins, located in Columbia Missouri USA. Check us out on http://instagram.com/brassengine