A320 or A3XX Tiller Hand Grip (captain and first officer side)

You could modify in certain degree to fit your flight sim setup.

Final version

3D PRINTING SETTINGS

I would recommend RESIN for better and fine appearance.But you will need to paint it in black

FOR PLA or PETG printing (Black)

Layer Height:

Recommendation: 0.1 mm to 0.2 mmExplanation: A smaller layer height will give you a finer resolution, capturing more details of your model.Print Speed:

Recommendation: 40 to 60 mm/sExplanation: Slower print speeds improve print quality by allowing the filament to cool and adhere properly.Print Temperature:

Recommendation: 200°C to 220°CExplanation: PLA generally prints well within this range, but you might need to adjust slightly based on your specific filament brand.Bed Temperature:

Recommendation: 60°CExplanation: Helps with bed adhesion, reducing warping and ensuring a smooth first layer.Infill Density:

Recommendation: 20% to 30%Explanation: Provides a good balance between strength and material usage. For non-structural parts, you can go lower.Shell Thickness:

Recommendation: 1.2 mm to 1.6 mm (3 to 4 perimeters)Explanation: Increases the strength and smoothness of the outer walls.Cooling:

Recommendation: 100% cooling fan speed after the first few layersExplanation: Helps PLA solidify quickly, maintaining sharp details.Adhesion:

Recommendation: Use a brim or raft if you experience warpingExplanation: Ensures that the model adheres to the bed during printing.Retraction Settings:

Recommendation: 1 to 2 mm retraction distance at 25 to 40 mm/s retraction speedExplanation: Minimizes stringing and oozing between parts.