CYD ESP32 Highend case-designed for larger power cell (18650 3.7v Li-ion or similar )-charging port space on the upperside-switch hole on the left side-simple screw on chassis for your CYD esp32-plenty of internal space for additional components-main chassis comes in wto variants: screw on option or in built (protruding) pivot-flip case can be either screwed or stuck to the case of your choice-stylus can snap on or be inserted into the case depending on your preferencesuse 3mm screws or similar to attach the cyd to your case-tree type supports with low density and wide branch angle are recommended for the flip panel print-main chassis does not require supports-at least 30 to 40mm/s printing speed and travel speed are necessary-requires a separately bought: power cell, CYD esp32, 3 pin switch, power cell (of choice) and a C-type USB 3.7v Li-ion charging boardDISCLAIMER: ANY ILLICIT OR ILLEGAL USE OF THE DEVICE IS HIGHLY DISCOURAGED AND DISAPPROVED, OUR PRODUCTS ARE INTENDED FOR EDUCATIONAL AND RECREATIONAL USE ONLY. ANY NON LAW ABIDING BEHAVIOUR IS NOT SUPPORTED OR ENCOURAGED.