A simple adapter for installing 52 mm gauges in 60 mm pods.

This particular adapter was designed for use in a triple gauge pod that goes on top of the center console. It has a slight tilt of 10° so the gauge can be installed facing the driver's seat instead of the rear seats.

Consider this before printing:

• You may need to glue the adapter to the pod.
• Use ABS or ASA to print (or better) Keep in mind that it will need to withstand high temperatures and sunlight.
• REMEMBER: if you print with ASA you need good ventilation. DON'T BREATHE THE GASES!
• Enable supports (only necessary for the outer ring).

That's all, good luck with your prints!