Spider-Man Homemade Suit 3D print model

Hello again guys! This is my Spider-Man Homemade Suit design from Spider-Man Homecoming movie! This model is made by me. You do not need High Priced models! Print and paint your own figures with very low prices and create your collection! Modelling time 8 Hours! The model is divided into two parts. Whole model and left arm. You need to print them all and put together. If you print them all with 0.1mm (100micron) layer height, you will not need sandpaper or any finishing techniques! :) I suggest, print this model with an air brush. I will share my painted model soon. Share your printings with me please! :)

CREALITY CR-10 PRINT SETTINGS

16 cm Spider-Man Homemade Suit

0.15mm (150micron) Layer Height %10 infill With support, 65 degrees 60 degrees bed heat 200 degrees nozzle heat PLA Filament

18 Hours Printing time. (The printing time may vary by the type of your printer and the size you want to print your model)

ARM

0.1mm (100micron) Layer Height %30 infill (my suggest) 65 degrees support 60 degrees bed heat 200 degrees nozzle heat PLA Filament

4 Hours Printing time for one arm. You will print the whole model about 1 day :)

No Need for sandpaper or any finishing techniques if you use 0.1mm layer height. Hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message! You can also send me a message for your bulk purchase to. See you on next projects!