When pulled back a span and released, it moves forward up to 5 meters!

• Compact size
• Strong structure
• Easy to print

Two versions are available:VERSION-1: PLA + TPU print (Only front and rear tires are printed with TPU filament)

VERSION-2: Full PLA print + rubber tubing for the rear wheels (You can cut old bicycle inner tubes into 1 cm pieces)

If you do not have TPU filament or your printer cannot print TPU, you can use this alternative. Since these wheels are smaller than the TPU wheels, this version can move up to 3 meters forward.

For proper installation watch the assembly video and follow the assembly diagram. You can access the assembly video via the YouTube link below.https://youtu.be/3TsHgbauvAg

Enjoy your car!

Suggested Slicing Parameters

• Material : PLA
• Nozzle :0.4 mm
• Layer Height : 0.2 mm
• Top/Bottom Layers: 4
• Top/Bottom Surface: Monotonic
• Plate Temp: 60 Celsius
• Infill : 10% Gyroid
• Brim: Auto

• NO SUPPORT!

• Material : TPU

• Nozzle :0.4 mm

• Layer Height : 0.2 mm

• Top/Bottom Layers: 4

• Plate Temp: Depends on the brand of your material

• Infill : 10% Gyroid

• Brim: NO

• NO SUPPORT!

• *** Print each wheel individually***