Scaled up the files to accomodate 1/6 action figures, but there were many a rough surfaces. Initially wrong files were in the downlad files, but the creator provided the correct ones. Some pre and psot processing required: One has to remove / lower the surfaces that touch the build plate by at least .65 mm ( in 200% print modus for 1/6 scale) and post process the top ( sand away) as it has a few protrusions and high spots. I had to remove the Pegs as they didn't fit the holes when scaling up, it might fit if you just print in 1:1 scale. And then you need to be aware of warpage: Only one in two prints I could use, so in the end spend about 5 kg of filament for a 2 kg model. Settings used 0.28 mm layer heigh, 1.2 mm top, 0.56 mm bottom, 15% infill. In the end I can't say negative or positive: for a 25$ file I would have expected a bit more ready to print file, on the other hand you can consider this a good starting point. Not for the beginner 3d printer-builder.