This is the basic He-man harness for the Masters of the Universe Origins collection. It uses the same two-part vertical clip system that I designed and already used in the Barbarian Harness (which by the way has been plagiarized on more than one occasion). It can be successfully printed in standard filament and resin, it doesn't need special flexible materials, much less recasting.

Content:-A generic harness top without badge (Part A).-6 snap-on badges: Vintage, Filmation, Revelations, He-Keldor/He-Skeletor, Snakemen and Evil Horde.-6 upper parts (Part A) with the badge attached, the Filmation version as an exception has less details.-A generic lower part (Part B)

This armor, being quite thin, tends to deform when cured in UV and open, so it does not close tightly. To avoid this problem, I have slightly bent all the upper parts (part A) inwards a little.Depending on the printing configuration, the socket on the chest that holds the badges may be a bit closed, it would need to be sanded to make it looser, it is better than sanding all the badges one by one.

Non-commercial use.

Designed by: RBL3D

www.deviantart.com/rbl3d

Socials:

https://www.facebook.com/RBL3D

https://www.instagram.com/rbl3d