DCAU Aquaman Belt Buckle 3D print model

This is a full size replica of Aquaman's belt buckle from the DC Animated Universe. The inside (side facing you) of the belt buckle was designed to increase comfort and reduce the chance of getting poked by a sharp edge. I recomend using a gold colored silk sash for the belt

4x4 ||| 1 part ||| About 2.5 hours to print

Recommented Printing Instructions:

• Wall Thickness: 1.2mm -Infill density: +40% -Supports: 10% or less, dont forget to adjust your support floor and support roof or you will hate life clearing out the supports

Finishing:

Careful about reaching into the slits with pliers. I used scissors to push and pliers to pull out the supports.