Custom bane fists with articulated wrist joint. I made these cause I was a little disapointed that the figure did not come with any fists of his own. Been working on them for a while now and I am pretty happy with them. Works best if printed with a resin printer. I use anycubic tough resin for the hands and a mixture of Resione M58 resin with Anycubic tough resin for the wrist joint. Comes with pair of hands, wrist band and spiked knuckles attachment. To attach the wrist joint to the hand I used a small alluminum wire, you can buy a spool at any hobby shop, cant remember the size of the wire, the hole on the hand and joint is 1.5mm in diameter. Be sure to put your figure in hot water to remove the existing hands as it is really hard to remove them. Then once removed I drilled the wrist hole a little bit bigger, this will help make switching between hands a lot easier.