Inspired by Dawn of Justice and Arkham Series. I've printed multiple of these in PLA + and Carbon Fibre and have not had any issues. You don't really need supports, I printed one with supports however PLA+ sticks too well to itself and Ilost some of the finer detail. Furthermore due to the low height 3mm, drooping is minimal. Does it throw? Horizontally yes, vertically no :)

This batarang measures at:

Length: 13.9 cm

Width: 6.24 cm

Height: 0.3 cm

I hope you enjoy this one and leave any feedback in the comments and if you have any questions don't hesitate to message me!Also check out the Batarang Stand I designed just for these!