I am new to 3D printing. But I believe this model is not good. I have printed a few things and they have come out fine. They were simple objects. This model is of an Among Us crewmen. It prints sitting on its back on the back pack. The back pack starts and is prints poorly. It is not smooth by any stretch of the imagination. After that it starts to print smoothly. Then whe it gets to the legs which protrude outwards the print messes up again. This part I believe needs supports. As I said. I am a novice, so this may be my lack of knowledge. No supports were part of this model. If this is something I am supposed to make then it is my fault. Either way the start of this model didn’t print well and it did not have to do with adhesion or movement of the printer. This seems to have been a waste of $4. To top it off it made my kid unhappy that it couldn’t be done correctly. I’ll gladly revise this review if I get a response.