I removed the overlapping side over the monitor because it would cover the corner of

bezel-less displays. Also, I adjusted the fit to allow for wider headbands as well as removed the angled corners for easier printing. I also reduced the size of the piece that holds on to the monitor because it was too wide for my LG Ultragear.

Included are both stls for left or right depending on your preference. As well as the .f3d files if you need to make any changes.

As you can see from the pics this is able to hold my pair of Sennheiser Game Zero's just fine. They weigh 300g (10.6 oz).

Print SettingsRafts:NoSupports:NoInfill:100Notes:Id recommend printing at 100% infill to ensure it is sturdy and will last.

Post-PrintingRemember to add a thin piece of double sided tape. I personally use the cheap stuff from harbor freight and it has held up for a while now. 3m would be overkill imo.