I printed on fdm Sidewinder x1 printer

For pumpkin. I printed the lid with a small defect, the stem did not print well, I think this is because I printed with abs plastic with a small thickness of the supports, I advise you to increase the degrees and thickness of the lid supports, good luck in printing!

Model content:

witch-hat(115mm) - parts welded

witch-hat-part-1(115mm)

witch-hat-part-2(48mm)

Rope-1(39mm) - ropes differ not only in length but also in knot

Rope-2(47mm)

pumpkin-version-1(82mm) - butt of the pumpkin is not smooth, it is detailed, I think it will be badly printed on a fdm printer, without entrails

pumpkin-version-2(80mm) - butt is clean, without entrails

pumpkin-version-3-part-1(80mm) - butt clean with puzzle for detailed butt

pumpkin-version-3-part-2(61mm) - detailed butt

pumpkin-version-4-part-1(77mm) - pumpkin with entrails, I advise you to reduce the thickness of the supports so that they can be easily removed.

pumpkin-version-4-part-2(47mm) - cap

pumpkin-version-4-part-3(61mm) - detailed butt