The Vault in the magical world is here now!I tried to pay attention to every detail of this Vault, which is my own design, from the bruises on the wall, the rust on the door to the dust particles on the floor.

It has 2 torches in front of it.Print them with Clear Resin and apply yellow/orange wash + gloss varnish.

3D printing settingsThis model was printed using an Elegoo Saturn 3 Ultra resin printer. For large prints, a 0.1mm layer height works perfectly fine. I used Anycubic resin with a 2-second exposure time per layer.

Scaling & Unit Conversion Notice:Sometimes, when fixing STL files, the unit of measurement can switch from millimeters to centimeters. If the model appears 10 times larger than expected, simply scale it down to 10% of its current size (reduce by one decimal place, e.g., 100mm >> 10mm).

When resizing multi-part models, make sure to scale all pieces by the same percentage to maintain proper fit and alignment, especially if the model includes connector pins or interlocking parts.

Since every printer and resin behaves differently, I can’t provide a one-size-fits-all setting. However, if you’re new to resin printing, you can easily learn by watching tutorial videos. There are plenty of great resources available!