This design includes one figure created as an incense burner. It is flat on the back and consists of three STL files. A 3/8 washer (known as three-eighths) is placed in this part, allowing it to rest on the edges so the filament doesn’t melt. If you use a smaller washer and it melts, that’s not a problem — the back piece is easy to replace since it’s separated from the main design and only attached by a simple joint. The full figure is also included in case you only want the decorative sculpture.Figure to print 117 mm high ( x ) 150 mm width ( y ) 81 mm depth ( z )