The Mandalorian 3 star wars statue 3D print model

When using a Elegoo Saturn 2 resin printer some of the model parts have Void spaces in the design that trap uncured resin during printing this leads to the model splitting over time and leaking uncured resin. I had to print the the model and then use a very small drill bit to drill into the Void spaces and allow the uncured resin to drain. Using Slicing software to hollow the model did not alleviate all of this problem.

Hello, thank you for your purchase, what you are saying is simply a printing parameter that you must configure at the moment prior to printing, there you must configure that the impression make holes in the part that you need to drain and if you want the piece is not hollow you must also configure the filling of this. thank you for your comment.

That is not at all what I’m saying I’m familiar with hollowing prints using slicing software. This is an issue with how the 3d model was made

Hi! I just want let you know, that Mando left boot is hollow.

let's check . thank you.

Good job