I printed on FDM ender 3 printer

Model content:

Archangel-body(56mm)

Archangel-chains(161mm) - I printed this option, probably it is weak for me, I think to strengthen it with epoxy resin, I advise you to print the second option or print this only with some kind of strong plastic

Archangel-chains-ver2(163mm)

Archangel-cloak(142mm)

Archangel-hands(59mm)

Archangel-jatpack(38mm)

Archangel-left-leg(103mm)

Archangel-left-wing - Pay attention, support is printed high in one place, I turned it so that I could reduce the number of supports, make the support settings thicker so that it could reach, or rotate the model as you need.

Archangel-right-leg(89mm)

Archangel-right-wing - Pay attention, support is printed high in one place, I turned it so that I could reduce the number of supports, make the support settings thicker so that it could reach, or rotate the model as you need.

Archangel-stand(176mm)

Archangel-stand-with-pazzle(176mm)

Archangel-sword(100mm)

Archangel-sword-2(97mm)

-----------------------sword--------------------------

hand(86mm)

sword(170mm) - I printed at an angle of 60 degrees to reduce vibration

sword-with-fire(175mm)

There are print defects in the photo, this is a printing problem and not a model.