My take on the Fep Frame for the Photon Mono 2.

Works fine on my machine.

Printed with ABS and or PETG.

Should work fine with PLA.

I just placed the FEP between the frame, set it on a table with a 1cm bottle cap in the middle to bulge the FEP up, punched holes in the FEP through the screw holes then position it on the vat. From there I just tighten the screws to stretch the FEP to the desired tension and went back printing.

Used a 140x200 mm thick 0.15mm FEP.

https://youtube.com/shorts/EgTIbNfUVCA?si=5sSwhoyFVLiTlJGf