Unleash your artistic vision by narrowing the beam of light with our snoot design for the Godox AD200 with Bulb head. Our STL file is intricately designed to perfectly fit the Godox AD200, ensuring a seamless and precise attachment. The Length of this snoot also allows for a Spotlight effect to allow further creativity! The size of the hole is adjustable within fusion 360 parametrers so you can change size of spotlight if you like.

PRINT AT 0.2MM

SPOTLIGHT EFFECT

*To change the size of the snoot : *

1. Open included Fusion 360 version of the file
2. Go to Change parameters under the Modify menu
3. Change the size of the parameter labeled Smaller to whatever size you desire.
4. Do not change size of shell unless required, or else snoot will not fit.

*Note this snoot fits perfectly on the bulb head of AD200 but Due to 3d printer differences you might have it is recommended that you pause the print after a few moments and check if the circled printed fits into the bulb slot with little issue. If it does not you can adjust the size to fit as such:

1. Open the included Fusion 360 version of the file
2. Go to Change parameters under the Modify menu
3. Change the size of the parameter labeled Bigger to either or bigger or smaller depending on what you need. I reccomend you to change by .5mm as it should not be too much off for most cases.
4. Changing the Bigger Parameter will change both the inner and outer circle. Do not change the Shell parameter as this should stay the same with all printers.