I made a test 3d printing, the height of the figure is 170 mm, everything is fine , I RECOMMEND figures smaller than 170 mm to use a chainsaw for figures of 75 mm .
two sizes of 170 mm and separately I made 75 mm
, a model for 3d printing . divided into parts for easy printing, 2 versions of the trunk . 2 versions with a gun in his hand and a hand on his belt . I would be very grateful if you would share where you are using my 3D model, Also ,
if you are satisfied with the purchase, please do not forget to rate and leave me a decent review. If you want to use a 3D model for 3D printing,
please check the model and if it needs any settings, you can contact me.
please leave a message here or in any of my profiles below:https://www.artstation.com/jenyk7 . Thank you again for downloading my work .