A highly detailed Bleach collector’s statue designed by Moyashi Studios for 3D printing.

Dimensions-Height: 29.2cm (11.5”)-Width: 22.7cm (8.9”)-Length: 28.8cm (11.3”)

Polygon count6mil total

DescriptionMatsumoto Rangiku is a lieutenant of the 10th Division within the primary military branch of Soul Society, the Gotei 13.She has long and wavy blond hair, blue eyes, full lips, and a beauty mark located under the right side of her mouth. She is well known for her curvaceous figure, especially her very large boobas. She dresses in the typical shihakushō of the Shinigami, though she lets her robes hang loose for her ample bosom to be revealed. She also wears a thin golden necklace tucked between her cleavage and a long pink scarf over her shoulders.Rangiku’s Zanpakutō; Haineko takes the form of a straight-bladed katana. The tsuba is in the shape of a cat's head, with two triangles on the top half curving into ear-points, and the bottom half tapering down into a single point.When unleashed, Haineko's blade turns to ash which disperses into the surrounding air. Rangiku can control these sharp particulates at will and slice her opponents from all directions.

Print DetailsModel comes split into 10 individual hollowed segments that are fully pre-supported in Lychee Slicer ready to go. Also included are unsupported STL files if you want to make your own modifications, scaling and/or support the model yourself. Do note this highly detailed figurine was designed with a 0.05mm (50micron) print resolution in mind (at 100% scale). It is thus advised that a 3D printer with similar or better print resolution be used to achieve the best results.Recommended printers include: Anycubic Photon M3 Max 7K, Elegoo Jupiter 6K and Phrozen Sonic Mega 8K.Also bear in mind that your print result is subject to your printer settings, type of resin used, temperature, humidity as well as resin shrinkage and warping during the curing process. Thus make allowances for slight differences, some sanding and gap sealing is to be expected.