A simple yet effective 3D Printing tree for architecture maquettes and scale modelsThe main objective was to create model which was extremely simple to print and that needs no polish. If printed upside down there is minimal support generation, for saving time and filamentFeatures are large and smoothed, for a guaranteed success rate; also dimensions can be altered a lot to fit most needsCan be printed hollow or in vase mode (I have posted shots of the slicer 's settings at 10% infill) Bottom is flat for glueing if needed

Topology is extremely clean, with only quads and tris in the original file (speeds up slicing and gives better results).ZPR file included for further customization

Original measurements:7.4 x 7.7 x 12.7 cm2.95'' x 3'' x 5''

22.692 vertices - 23.106 faces - 45.379 tris