Balinese Om symbol pendant or keychain 3D print model

Prepared to printing completely diagnosed as NO ERRORS and no artefacts STL files and 3DM source files of Balinese version of Om symbol with bezel presented in few design subversions.

Model is separated to two parts (Bezel and Om symbol). If you don't like soldering, I can provide single-piece models by demand.

The set contains two versions of bezel orientation and Om symbol with and without jump ring. Both versions of the bezel are prezented with and without jump rings (the same with the Om). Also as bonus or as reserve part (e.g. for possible design changes) added blank bezel (without the place for Om).

So from this model set can be produced pin, broche, keychain etc.

Parts volumes:

• Blank bezel 428mm^3 (ca. 4.2g for sterling silver);
• Om symbol 248mm^3 (with jump ring) or 244mm^3 (version without jump ring) (ca. 2.4g for sterling silver);
• Cumulative volume (bezel + symbol) ~655mm^3 (~6.5g for sterling silver);
• Bail 37mm^3.