BLUETOOTH SPEAKER IMPROOVED PARLANTE 3D 3D print model
I made some huge modifications to the model. It just was impractical from the very design. The holes for electronics was too much. The bateries were hanging in the air, depending on some kind of glue.. just not well thought in my opinion. I designed some holders that fit perfectly and some other improoves. It just fit everything perfect. Even the rubber base didnt fit! Also i'll tel you the components you realy need and give you some photos. Meterials:
- Speaker 50x50mm - 4ohm - 3watt - 2inch
- Charge Module Micro Usb 5v Tp4056 for bettery 18650 with protection ( 26 x 17 mm)
- On-Off switch. (doble and triple check the sice before buying one!)
- Two Rechargeable Batteries 18650 - 3.7v Yes, only two! Mine goes for almost a week without charging and regular use. You can always put some extra in parallel with the holders I design.
Original video: https://www.youtube.com/watch?v=u0eKCRtysro
PARÁMETROS DE IMPRESIÓN 3D 0.2 to 0.4 0.4 or 0.6 nozzle 3 walls 20% infill