Useful 3D print for making a stand for plants or small appliances. I use it as a stand for the humidifier in my bedroom. The top of the stand will be decoupaged (link to blog post - http://clevercrafts.blog/2021/03/19/first-decoupage-project/).
This set contains a two part bracket consisting of a flange and outer screw on decorative part. A foot cap is included to complete the set. Fits 1" (25.4 mm) dowels.
M6 screws needed to attach flange to stand top and leg. M6 screws needed to attached foot cap to dowel leg.
Purple set printed with Printlife purple. Translucent Amethyst from Atomic used for the other sets.
Settings (Cura 4.6): (Grape Outer) Temp- 204 degrees (Translucent Amethyst) 210 degrees (Purple), Layer height-.2, Wall line count-1, Thin walls enabled, Infill-20%, Infill pattern-cubic, Build plate adhesion-skirt.