Purge Trooper Helmet 3D print model

Yep. But I have a big printer, so I printed the main helmet in one chunk at 85 and then again at 90% scale. My son loves it thanks! Of course to print it I rotated it so the main helmet was mostly flat on the build plate. It worked well and it is wearable. From a wearable standpoint it would be handy to integrate the nose with the main helmet, but from a resolution standpoint, it is nice that it is separate so you can print it out at higher res. It also prints with a 0.5mmm nozzle as small as 25% scale, but 40% is much better.

Woo, I'm glad you enjoy it! Yeah I didn't realize until after I built the helmet that it does slightly crush the nose. I had to got a soldering iron and melt a hole and fill it with soft foam.

Did you print it with the orientations shown in the STLs?

I didn't. I cut it in half horizontally, and then from there I cut the top dome into 4 pieces, the front piece into 4 pieces, and the back piece into 2 pieces, if that makes sense?

It doesn't, it only comes in the pieces you see in the 5th picture. However, I can merge the parts together so that it can be scaled easier, but the gaps between them will still be there since I modeled it that way, which means if you print it all as one piece, there'll be problems.

does this come in one piece for smaller scale? or can it? thanks! i read the descpt...kinda not sure what you meant