There are 2 versions of him, one for regular printing and one prepeared to put 5mm LEDs to each eyesockets (the round head of the LED becomes the eyehole) plus chanels trough the body and base for wireing. This version's base is hollow, leaving enough room to house any electronics you choose to design. For this version I recommend SLA printing for the head or upscaling it in order to preserve the shape of the eyes.Downscaling the normal version could lead to artifact in the print, due to thin parts that had to be made to maintain his proportions.If for some reason the scaling goes sidevays I included a whole version for bot that includes all the parts yet all of them are seperate plus I included a picture with correct sizing.There is an additional base that I did not finish becuase I did not like the way it was going but it is useable if you prefer that version.