Bedside lamp with different possible configurations

Printable with minimum print area 220x220x250 (similar to Ender3, U30, TarantulaPro, etc.)

Finished object size:about 210x130x290mm

Possible configurations:Structure without light:

• dancer down
• dancer upward

Structure with light:

• light at the bottom and dancer down
• light at the bottom and dancer upwards
• light at the top and dancer down
• light at the top and dancer upwards

with the basement (optional), all the configurations can be rotated by 45 degrees

compare the attached photos for some examples

3D PRINTING SETTINGS

dancer and structure: recommended layer 0.15optional parts: layer 0.20supports:with the suggested orientation, the supports are reduced to a minimumcompare attached photos

post production:pass the cable through the structuresolder the LED lightinsert the LED light in the appropriate holderinsert the holder into the structure. if necessary, use a glue point.

uses a Led light of this type or equivalent (diameter 26mm).type220vhttps://it.aliexpress.com/item/33006463442.html?spm=a2g0s.9042311.0.0.3da24c4dAsAvxNthe light used is 3watt (after 10 hours of continuous use the maximum temperature was around 35 degrees. no problem even for PLA prints)

look also at my other creations:

• CoffeeKiss, coffee service
• Complete set of fantasy style chess