Transformers Decepticons Molecular Cannon from G1 3D print model

When the peace-loving planet of Paradron was taken over briefly by the Decepticons, they immediately turned it around into becoming a planetary war machine. Amongst these evil weapons, one which was put to quick use was the Molecular Cannon!

The cannon was designed to be sited upon a standard CBS Base Tile, and so can be used to extend any CyberBase setup which you already have.

A target acquisition monitor is set into the back of the cannon, with a pair of handles to control and fire this beast.

Near the rear of the base piece are a pair of 5mm ports which can be connected up with rubber tubing. Can't power up this mega weapon without some good flow of energon from Paradron's endless energon fountain!

As an alternative configuration, there are also 5mm ports on either side of the cannon's body, so the tubing can be routed that way too. Or these ports can be used for other accessories or effect parts!

=== Assembly ===

The included diagram shows the parts in this kit and how they are to be assembled:

As an alternative, a single Body_Whole piece has also been provided which can be used in lieu of the Body_Front and Body_Back parts.

===

Enjoy 3d printing and adding this dastardly weapon to your Decepticons' CyberBase arsenal! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog