Starscream Coronation Stage from Transformers the Movie 3D print model

What better way for Starscream to take over command of the Decepticons than on a magnificent Coronation Stage surrounded by all the loyal (for now) followers!

With the overly long fanfare being belted out by the Constructions on the earlier Coronation trumpets ( https://www.patreon.com/posts/51834663 ), Astrotrain grandly lowers the crown ( https://www.patreon.com/posts/39843419 ) onto Starscream's noggin.

Of course, this piece sports its massive Decepticon logo on the back pillar.

=== ASSEMBLY ===

Now, being the size that it is, the stage has been separated into parts for easier printing. These bits then need to be put together as follows:

As usual, the parts can be optionally connected using 5mm pegs of your choosing, or by 3d printing the provided 5x18mm pegs.

One thing to note is that the geometry of the piece may make it difficult to have all the pegs in place. Thus as long as you have enough to align the parts, that should suffice.

If you don't mind having the whole piece permanently glued together, superglue would be your best bet!

===

Enjoy adding this to your display to highlight the bad comedy of Starscream's coronation! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog