Radar Dish for Transformers WFC Earthrise Trailbreaker 3D print model

From way back in the early days of the G1 pilot, here's the radar dish which we saw Trailbreaker use to listen in on the Decepticons as they plotted their nefarious plans!

Trying to be accurate to its on-screen appearance, this was designed as two parts - the dish and the stem, so it can rotate to both point forwards and upwards and every angle in between.

And never one to give up the chance to make things effect parts compatible, the antenna is sized to allow for these to be added for more a bloosh display.

As a slight fun detail, a variant set of this dish sports a small notch on the back of both the dish and stem parts, sized to around 2mm.

Thus, with a small length of black flexible filament, these can be connected to look like they have a wire running between them much like how it appeared on screen. As a side note, this would need to be removed if you would like to rotate the dish up and down, so it's probably a good idea not to glue it permanently in place.

Enjoy spying on the Decepticons with this little addon for Trailbreaker then! Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog