CyberBase System Space Bridge Receiver

CyberBase System Space Bridge Receiver 3D print model

Description

Here's the final topper piece for the Space Bridge Elevator (https://www.patreon.com/posts/34735568) + Shockwave's Tower (https://www.patreon.com/posts/34820558) which were done earlier. This flower-like part operates like a dish to receive whatever the Decepticons beamed from the Earth-based Space Bridge back to Cybertron.

The central ring portion of this piece is made up by 3 portions which can be glued together. The 12 outer tabs can then be pegged onto the central ring using 2mm pegs and the entire assembly should fit snuggly on top of the earlier Shockwave's Tower.

By default, there isn't a lot of vertical space if you just put this on top of Shockwave's Tower. So to address this, additional sections of Shockwave's Tower can be 3d printed and stacked up to give it the vertical height you like.

Well then, that's the entire space bridge tower complete then! Hope everyone has fun 3d printing and putting this one together! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios

Item rating
0 0
CyberBase System Space Bridge Receiver
$4.00
 
Editorial No Ai License 
CyberBase System Space Bridge Receiver
$4.00
 
Editorial No Ai License 
Response 80% in 1.8h

3D Model formats

Format limitations
  • Stereolithography (.stl)984 KB

3D Model details

  • Publish date2020-04-30
  • Model ID#2396208
  • Ready for 3D Printing
Help
Chat