V
veritech100 veritech100
Ok for a starting off point, but took many hours to clean up and fix geo. Crooked offset booleans irregular non symmetrical data .
Useto navigate. Pressescto quit
Catapult from Transformers The Movie 3D print model
Description
Phew, this one took a little bit of time to put together but here is it - a working version of the catapult from Transformers: The Movie!
Inspired by Springer's loading of the catapult from the rear (whilst proclaiming his full social calendar), a loading chamber features was also designed into this piece. The way it works is when empty, you'll need to load two rounds, so the second missile will push the front missile forwards and upwards onto the catapult's rails (may need to fidget it a little sometimes :)
The missiles themselves have a standard 5mm peghole on the back which allow for siege effects to be added on. So it's fun to even just 3d print a whole bunch of them for display:
This model may be a little confusing to assemble, so here attached also is a helpful guide showing how the pieces go together. The shooting action is powered by a rubber band which notches onto the front post, stretched and tied off onto the circular hole on the bottom of the bow part. Where there are peg holes, 5mm rods can be used to connect everything together.
Here's a short video of it showing the features and how it all comes together - https://www.youtube.com/watch?v=T3lfXK9eCM0
Have fun 3d printing and putting this one together! =)
===
This model is not to be uploaded or sold in any form and is intended for personal use only.
Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)
Support us on Patreon - https://www.patreon.com/FunbieStudios
Similar Models
to Catapult from Transformers The Movie
