Hello everyone, this time I brought a very cute mini car model. The prototype is modified according to the Fiat 500. The rounded shape will make it more attractive. At the same time, I added the suspension designed by me, so you can experience the fun of assembly.Body length 16cmI used PETG filament for the suspension, and PLA filament for the rest of the parts. The fog lamp part was printed with transparent PLA filament.Four springs were used, their model is 0.6*6 30mm height, but I cut off a small part.Two types of screws were used: front suspension M2*10 (4 pieces) M2*16 (8 pieces)Rear suspension M2*10 (14 pieces)Suspension connection M2*10 (2 pieces) (All screws require M2 nuts)After installation, a small amount of screw glue is needed to prevent the nuts from loosening.

For smaller parts such as handles and trunk handles, you can take a small section of filament and cut it with a knife to make it thinner so that it can be inserted smoothly.