Transformers StarScream Energon Canon and Energon Cubes 3D print model

Here's another piece from the good ol' Generation One days - Energon Canon which Starscream built to test the potency of the Energon Cubes!

The Energon canon comes simply as two parts, which connect both top and bottom pieces using a 5mm peg. This allows for the top to swivel as you like.

The canon stand also has a 5mm port which can be connected to the stack of Energon Cubes (also with a 5mm port) using a piece of rubber tubing or something similar.

The stack of Energon cubes themselves come in 3 parts and can be stacked as show below. For good measure, a single Energon Cube has also been provided.

On top of the canon is a Prime Master port, which allows one of them to be added to supercharge the canon! More blooosh!

The set has a canon which is compatible with the CyberBase System, which comes with 2 pegs that allows it to be connected to the corresponding baseplates.

Hope this will be a fun addition to your displays! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios